Updated Cisco 640-864 PDF & VCE Free Download Now (91-100)

Lightweight access points are being deployed in remote locations where others are already operational. The new access points are in a separate IP subnet from the wireless controller. OTAP has not been enabled at any locations. Which two methods can the AP use to locate a wireless controller? (Choose two.)

A.    NV-RAM IP address
B.    master
C.    primary, secondary, tertiary
D.    DHCP
E.    local subnet broadcast
F.    DNS

Answer: DF

Which Cisco security solution can quarantine and prevent non-compliant end stations from accessing the network until they achieve security policy compliance?

A.    Cisco Security Monitoring, Analysis, and Response System
B.    Adaptive Security Appliance
C.    Network Admission Control
D.    Network Intrusion Prevention System
E.    Cisco Secure Connectivity
F.    Access Control Server

Answer: C

A network design includes private addressing, but there is also a need for two or three network devices to each be assigned a unique public address so they can be accessed from the Internet.
Which technique will satisfy this requirement?

A.    Static NAT
B.    VPN tunneling
C.    Dynamic NAT
D.    DHCP

Answer: A

A Cisco security mechanism has the following attributes:
– It is a sensor appliance
– It searches for potential attacks by capturing and analyzing traffic
– It is a “purpose-built device”
– It is installed passively
– It introduces no delay or overhead
Which Cisco security mechanism is this?

A.    NIDS
B.    PIX
C.    IKE
D.    HIPS
E.    HMAC

Answer: A

Which two routing protocols operate over NBMA point-to-multipoint networks without the use of
point-to-point subinterfaces? (Choose two.)

A.    OSPF
C.    RIPv2
D.    RIPv1
E.    IGRP
F.    IS-IS

Answer: AB

Which three types of WAN topologies can be deployed in the Cisco Enterprise Architecture Enterprise Edge WAN module? (Choose three.)

A.    ring
B.    full mesh
C.    partial mesh
D.    collapsed core
E.    star
F.    core
G.    edge

Answer: BCE

Which statement accurately describes one difference between a small office and medium office topology?

A.    Medium offices commonly use integrated route and switching platforms.
B.    Medium offices use integrated 10/100/1000 interfaces as Layer 2 trunks.
C.    Medium offices use external access switches to support LAN connectivity.
D.    Small offices commonly use Rapid PVST+ for Layer 3 deployments.

Answer: C

A customer has the following Enterprise Campus design requirements:
at least 10 Gbps of bandwidth
network runs of up to 40km
no concern for transmission medium cost
Which transmission medium should you recommend to this customer?

A.    unshielded twisted pair
B.    shielded twisted pair
C.    single-mode fiber
D.    wireless
E.    multimode fiber

Answer: C

You design a network with the following network addresses:
Which route address is the best summary of these network addresses?

F.    None of the above

Answer: B

Which two of the following statements represent a preferred wireless LWAPP implementation? (Choose two.)

A.    verify open ports for:
Layer 2 LWAPP on ethertype OxBBBB
Layer 3 LWAPP on UDP 12222 and UDP 12223
B.    use of Layer 3 LWAPP is preferred over Layer 2 LWAPP
C.    use of Layer 2 LWAPP is preferred over Layer 3 LWAPP
D.    verify open ports for:
Layer 2 LWAPP on ethertype OxBABA
Layer 3 LWAPP on UDP 12222 and TCP 12223
E.    verify open ports for:
Layer 2 LWAPP on ethertype OxABAB
Layer 3 LWAPP on TCP 12222 and TCP 12223

Answer: AB

If you want to pass Cisco 640-864 successfully, donot missing to read latest lead2pass Cisco 640-864 dumps.
If you can master all lead2pass questions you will able to pass 100% guaranteed.