[Q361-Q370] Latest 300-101 Dumps PDF Free Download In Lead2pass

Free Sharing Of Cisco 300-101 Brain Dumps From Lead2pass:

https://www.lead2pass.com/300-101.html

QUESTION 361
To enable BGP tunneling over an IPv4 backbone, the IPv4 address 192.168.30.1 is converted into a valid IPv6 address. Which three IPv6 addresses are acceptable formats for the IPv4 address? (Choose three.)

A.    192.168.30.1:0:0:0:0:0:0
B.    0:0:0:0:0:0:192.168.30.1
C.    ::192.168.30.1
D.    C0A8:1E01::
E.    192.168.30.1::
F.    ::C0A8:1E01

Answer: BCF

QUESTION 362 300-101 Dumps,300-101 Exam Questions,300-101 New Questions,300-101 VCE,300-101 PDF
Which two statements are true about using IPv4 and IPv6 simultaneously on a network segment? (Choose two.)

A.    Hosts can be configured to receive both IPv4 and IPv6 addresses via DHCP.
B.    Host configuration options for IPv4 can be either statically assigned or assigned via DHCP.Host configuration options for IPv6 can be statically assigned only.
C.    IPv6 allows a host to create its own IPv6 address that will allow it to communicate to other devices on a network configured via DHCP. IPv4 does not provide a similar capability for hosts.
D.    IPv4 and IPv6 addresses can be simultaneously assigned to a host but not to a router interface.
E.    IPv6 provides for more host IP addresses but IPv4 provides for more network addresses.

Answer: AC
Explanation:
Like DHCP in IPv4, IPv6 hosts can also be configured to acquire connectivity parameters from DHCPv6 servers. IPv4 clients use DHCP broadcasts to locate DHCP servers, and since broadcasts are extinct in IPv6, clients use specialized multicasts to locate DHCPv6 servers. These multicasts use the reserved address FF02::1:2. One notable difference between DHCP and DHCPv6 is that while DHCP can inform clients which node to use as the default gateway, DHCPv6 does not do this.

QUESTION 363 300-101 Dumps,300-101 Exam Questions,300-101 New Questions,300-101 VCE,300-101 PDF
Under which circumstance will a branch ISR router contain interface vlan configurations?

A.    performing inter-VLAN routing
B.    performing 802.1Q trunking
C.    performing ISL trunking
D.    Ethernet Switch Module installed
E.    ADSL WIC installed
F.    running Call Manager Express

Answer: D
Explanation:
In smaller offices, a single ISR may be used for a both remote connectivity and inter-VLAN routing. In that case, know that an Ethernet Switch Module would be required for the ISR router

QUESTION 364 300-101 Dumps,300-101 Exam Questions,300-101 New Questions,300-101 VCE,300-101 PDF
Which statement describes the difference between a manually configured IPv6 in IPv4 tunnel versus an automatic 6to4 tunnel?

A.    A manually configured IPv6 in IPv4 tunnel allows multiple IPv4 destinations.
B.    An automatic 6to4 tunnel allows multiple IPv4 destinations.
C.    A manually configured IPv6 in IPv4 tunnel does not require dual-stack (IPv4 and IPv6) routers at the tunnel endpoints.
D.    An automatic 6to4 tunnel does not require dual-stack (IPv4 and IPv6) routers at the tunnel endpoints.

Answer: B
Explanation:
An automatic 6to4 tunnel allows isolated IPv6 domains to be connected over an IPv4 network to remote IPv6 networks. The key difference between automatic 6to4 tunnels and manually configured tunnels is that the tunnel is not point-to-point; it is point-to-multipoint -> it allows multiple IPv4 destinations .
Manually 6to4 is point-to-point -> only allows one IPv4 destination. Configuring 6to4 (manually and automatic) requires dual-stack routers (which supports both IPv4 & IPv6) at the tunnel endpoints because they are border routers between IPv4 & IPv6 networks.

QUESTION 365 300-101 Dumps,300-101 Exam Questions,300-101 New Questions,300-101 VCE,300-101 PDF
Refer to the exhibit. Based upon the configuration, you need to understand why the policy routing match counts are not increasing. Which would be the first logical step to take?

3651

A.    Confirm if there are other problematic route-map statements that precede divert.
B.    Check the access list for log hits.
C.    Check the routing table for 212.50.185.126.
D.    Remove any two of the set clauses. (Multiple set clause entries will cause PBR to use the routing table.)

Answer: B
Explanation:
First we should check the access-list log, if the hit count does not increase then no packets are matched the access-list -> the policy based routing match counts will not increase.

QUESTION 366 300-101 Dumps,300-101 Exam Questions,300-101 New Questions,300-101 VCE,300-101 PDF
What is IPv6 router solicitation?

A.    a request made by a node to join a specified multicast group
B.    a request made by a node for its IP address
C.    a request made by a node for the IP address of the DHCP server
D.    a request made by a node for the IP address of the local router

Answer: D

QUESTION 367 300-101 Dumps,300-101 Exam Questions,300-101 New Questions,300-101 VCE,300-101 PDF
What are three reasons to control routing updates via route filtering? (Choose three).

A.    to hide certain networks from the rest of the organization
B.    for easier implementation
C.    to control network overhead on the wire
D.    for simple security
E.    to prevent adjacencies from forming

Answer: ACD
Explanation:
Route filtering hide certain networks from the rest of the organization and it also controls network overhead. Not only this, it also provides security to the routing updates.

QUESTION 368 300-101 Dumps,300-101 Exam Questions,300-101 New Questions,300-101 VCE,300-101 PDF
ALWAYS block the outbound web traffic on Saturdays and Sunday between 1:00 to 23:59

A.    periodic Saturday Sunday 01:00 to 23:59 and IN
B.    periodic Saturday Sunday 01:00 to 23:59 and OUT
C.    periodic Saturday Sunday 01:00 to 11:59 and IN
D.    Absolute Saturday Sunday 01:00 to 11:59 and IN

Answer: B

QUESTION 369 300-101 Dumps,300-101 Exam Questions,300-101 New Questions,300-101 VCE,300-101 PDF
Drag and Drop Question
Drag and drop each statement about uRPF on the left to the correct uRPF mode on the right.

3691

Answer:

3692

QUESTION 370 300-101 Dumps,300-101 Exam Questions,300-101 New Questions,300-101 VCE,300-101 PDF
Which statement is true about IPv6?

A.    Only one IPv6 address is assigned per node.
B.    Only one IPv6 address can be assigned to each interface.
C.    Each host can auto configure its address without the aid of a DHCP server.
D.    IPv6 hosts use any cast addresses to assign IP addresses to interfaces.

Answer: C

300-101 dumps full version (PDF&VCE): https://www.lead2pass.com/300-101.html

Large amount of free 300-101 exam questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDbHBiVVk1ZVhpOGc

You may also need:

300-115 exam dumps: https://drive.google.com/open?id=0B3Syig5i8gpDM0pqaFJWUXVuM2M

300-135 exam dumps: https://drive.google.com/open?id=0B3Syig5i8gpDZmFQVlZDZnpLejA